How-to

Cleaning a soft serve or shake machine

The full cleaning and sanitizing routine with KAY-5 cleaning powder. Your machine’s operator manual and the product label come first; use this as a checklist alongside them.

  1. Empty the machine

    Remove all mix from the machine.

  2. Rinse

    Run the Wash cycle and draw about 2 gallons (7.6 L) of lukewarm water through the cylinder and feed tubes. Repeat until the water runs clear, then turn the machine Off.

  3. Mix the cleaning solution

    Dissolve 1 packet of KAY-5 in 2½ gallons (9.5 L) of lukewarm water.

  4. Clean the inside

    Run Wash and fill the cylinder and feed tubes with the solution, then turn the machine Off. Brush the feed tube and inlet hole. Run Wash again with the solution in the cylinder and let it run for 5 minutes.

  5. Drain

    Drain the solution and turn the machine Off.

  6. Take it apart

    Remove and fully disassemble the machine parts: door, blades, pump and so on.

  7. Wash the parts

    Brush-wash every part in a suitable detergent in a clean sink.

  8. Rinse the parts

    Rinse everything well under clean running water.

  9. Sanitize

    Soak the parts for at least 1 minute in a fresh KAY-5 solution (1 packet in 2½ gallons of lukewarm water).

  10. Air dry

    Take the parts out and let them air dry.

  11. Second cylinder

    On machines with two freezing cylinders, repeat the procedure for the second one.

Before you put it back together

The machine is fully apart, so check the o-rings. Replace any that are flat, cracked or stretched; our o-ring kit has the full set for Stoelting E111, F111, F131, F231 and O231 machines. When the auger goes back in, put a small amount of spline lubricant on the hex end of the shaft.